[WriteLog] Fwd: Re: [Dx4win] new mystery

[Joe Subich, W4TV]

> SSB/vox works just fine. so went to options in mmtty and discovered
> somehow under DEVICES it was showing -1, changed those to 1 and all
> is back to normal again.

In the future, check the "SoundCard" tab in MMTTY | Config rather than
the Misc tab.  The SoundCard tab provides a list - with "radio" buttons
for selection - of available sound cards.

Device -1 in the "Misc" tab is the Windows Default card (which should
*never* point to either Line or Headset Mic inputs of microHAM CODEC).
1 is something else (the SoundCard tab will tell you).

In any case, follow the "Configuring microHAM CODEC" section of the
microKEYER II Users Manual and *don't* open the MMTTY (or PSK) Window
of DX4win while running phone (if you expect to be able to record DVK
messages).

73,

    ... Joe, W4TV

On 7/19/2016 9:22 AM, Courtney Judd wrote:
>
> thanks for the response Joe.... everything was all ok with the
> router.... spent a lot of time with it.... ended up deleting everything
> and started over with new presets.... problem was still there. Thought
> about this several times during the night and decided it had to be a
> dx4win issue as that was the only time it showed up. So this morning I
> was going over and over the preferences in dx4win and thought about the
> rtty/mmtty window being open. I closed it and problem went away. SSB/vox
> works just fine. so went to options in mmtty and discovered somehow
> under DEVICES it was showing -1, changed those to 1 and all is back to
> normal again.  Life was much simpler under XP... guess win 10 must have
> changed those values. Took me over 5 hours to sort this out... but all
> is good now! Thanks for all the suggestions! 73's Cort K4WI
>> microHAM Support (W4TV) <mailto:support at microham.com>
>> Tuesday, July 19, 2016 8:03 AM
>>
>>
>> Is microHAM Router properly following the frequency and mode of your
>> transceiver?
>>
>> What are the settings on the Audio Switching tab in microHAM Router?
>> Is the Voice/Digital settings selector set to "Use Voice Settings"?
>>
>> Is "Computer generated audio fed to:" set to "Microphone jack, DVK
>> Control" for voice?
>>
>> Your symptoms indicate the audio is set improperly with the mic
>> routed *through* the sound card/computer.  When MMTTY opens, the
>> sound card input is switched from mic to line disabling your audio.
>>
>> 73,
>>
>> ... Joe Subich, W4TV
>>     microHAM America, LLC.
>>     http://www.microHAM-USA.com
>>     http://groups.yahoo.com/group/microHAM
>>
>>     support at microham.com
>>
>>
>> This message, including any attachments, may contain proprietary,
>> confidential or privileged information for the sole use of the
>> specific individual(s) to whom it is addressed. You are hereby
>> notified that any disclosure, copying, distribution, or use of this
>> message is prohibited. If you have received this message in error,
>> please immediately notify the sender by reply e-mail and delete it.
>>
>>
>>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>