Amps
[Top] [All Lists]

Re: [Amps] Vacuum relays in Dentron MLA-2500

To: "David A. Pruett" <k8cc@comcast.net>,"Don Knight" <n4dek@triad.rr.com>, <W8AV@aol.com>,<amps@contesting.com>
Subject: Re: [Amps] Vacuum relays in Dentron MLA-2500
From: Pete Smith <n4zr@contesting.com>
Date: Fri, 26 Dec 2003 17:11:12 -0500
List-post: <mailto:amps@contesting.com>
At 04:52 PM 12/27/03 -0500, David A. Pruett wrote:
However, if you put vacuum relays in, I'll bet the 4PDT will become the next level of annoyance.

Most vacuum relays used by hams are 26 VDC. All of these relays have 12 VDC coils, so the relay supply in the MLA-2500 is 12 VDC. My friend N8CC ran an HC1 vacuum relay in his MLA-2500 by changing the relay supply rectifier circuit to a voltage doubler.

Vacuum relays are to be preferred from the speed and voltage handling standpoint, but many amps get by with open frame T/R relays. The SB-220, for example, while not totally quiet is a lot less annoying than the MLA-2500. It uses essentially the same relay, but mounts it to the amp chassis through a rubber grommet. This might be a viable approach to get quieter without requiring extensive re-design.


I can testify that, even when isolated with a strip of silicon rubber around its circumference, the HC-1 vacuum relay in my modified SB-220 is noisier than the original open-frame relay. Before you do radical surgery, try Dave's suggestion, and maybe substitute some short flexible braid for any rigid wire connections to the relay, all in an effort to isolate contact vibration from the chassis, which acts as a sounding board.


73, Pete N4ZR Happy Holidays Check out the World HF Contest Station Database at www.pvrc.org/wcsd/wcsdsearch.htm



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>