Thanks much Ian,
I downloaded pusd and expanded rectifiers file. Will give it a whirl.
Larry N5BIP
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Ian White G/GM3SEK
Sent: Tuesday, October 04, 2005 9:05 AM
To: amps@contesting.com
Subject: Re: [Amps] Energy stored in capacitor bank ?
Larry Carman wrote:
>I try to keep the HV PS capacitance at about 25uF with a 50% safety
>margin. All the amps I've built have used 3800VDC to 5000VDC at one to
>two amps. Oh! in a couple supplies I used a choke input with about 12
>uF. All seemed to work nicely for me. I've never ran the lower voltage
>tubes, say around 2000 VDC, but I guess 35 uF would be more adequate
>for 1.5 plus amperes at 2000 VDC than 25 uF.
>
>There has to be a chart somewhere out there on the www that shows
>ripple percentage based on voltage, current and capacitance. Maybe it's
>in the ARRL handbook somewhere. What would be better is an on-line
>calculator to take the brain work out of it. If anyone has or finds
>this, let me know so I can put it on my website.
>
The 'PSU Designer' program ends all the guesswork.
Follow the links from my site, and also collect the expanded rectifiers
file for HV supplies:
http://www.ifwtech.co.uk/g3sek/in-prac/best-of.htm#psud
--
73 from Ian G/GM3SEK 'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|