6C21 = Pulse rated 450TH I had a pair of NIB Matchletts but never got
around to using them. Got lucky with a bunch of local 4-1000A BC pulls
instead.
Carl
KM1H
----- Original Message -----
From: "Roger" <sub1@rogerhalstead.com>
To: <amps@contesting.com>
Sent: Friday, September 14, 2007 8:10 PM
Subject: Re: [Amps] switching power supply for tube amplifier
>
>
>
>> Hamilton Horta - PY2NI wrote:
>>> It has been done.... see http://w5jgv.com/amateur_radio.htm
>> Down the bottom of the page there's some interesting archive
>> stuff. Can anything as neat and tidy as the 813 amps really work? :-)
>
> Sho Nuff...I built a modified version way back then. It used a band
> switching B&W PI network. Worked like a champ. OTOH I didn't have the big
> meter rackin mine
>
> It looked a lot neater than my original 6C21 on 80 through 20. Not nearly
> as
> impressive visually though <:-)) I picked up a bunch of those 6C21s for $5
> each as no one wanted them. Now they cost a small fortune. I saw an amp
> using a pair of them on 6-meters. IIRC there was an article in QST on it
> as
> well. Being RADAR pulse modulator tubes they had enough cathode emission
> to
> blow the plate right out of one. They were about 16" tall and a bear to
> neutralize. Looked similar to a 250TH on steroids.
>
> 73
>
> Roger (K8RI)
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|