Amps
[Top] [All Lists]

Re: [Amps] 240V Outlet

To: "amps@contesting.com" <amps@contesting.com>
Subject: Re: [Amps] 240V Outlet
From: "Jim Brown" <jim@audiosystemsgroup.com>
Date: Tue, 11 Aug 2009 13:31:03 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
--Original Message Text---
From: Gudguyham@aol.com
Date: Tue, 11 Aug 2009 07:43:59 EDT

In a message dated 8/11/2009 3:28:13 A.M. Eastern Daylight Time, 
jim@audiosystemsgroup.com writes:

NO. NO! NO! The advice quoted below is NOT mine. My post took strong 
exception to the advice quoted below. 

>You should not change the outlets. NEMA 5-20P plugs come installed 
>only on equipment drawing just under 15 amperes up to 20 amperes. 
>If the equipment draws this much current, it should have a 
>dedicated circuit. Using NEMA 5-20R receptacles for general purpose
>outlets invites you to easily overload the circuit. All you have to
>do is plug in two items using this configuration.

In response to the above, I said:

You have a rather limited view of a world that far more varied than 
you imagine. I work in the world of pro audio, and there are many 
occasions where a product may be rated for 20A service but have very 
dynamic load requirements and draw FAR less current in real world 
applications. Audio power amplifiers are a good example -- a big 
power amp may draw 15-18A with both channels near clip on sine waves 
or very dense audio, but operating them under those conditions would 
be VERY rare outside of a test lab. Another example is a series mode 
surge suppression rated for 20A, with a 20A plug. There are MANY 
other examples that could be cited, none of which justfiy a 
dedicated circuit for a single product ONLY because it has a 20A 
plug.

73,

Jim Brown K9YC


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>