TenTec
[Top] [All Lists]

[TenTec] microphones and ten tec gear

To: <tentec@contesting.com>
Subject: [TenTec] microphones and ten tec gear
From: n1eu@hotmail.com (Barry N1EU)
Date: Sat, 12 May 2001 14:59:09 -0400
If the culprit is an improper setting of carrier set point (aka "carrier 
offset"), then you should notice your RECEIVED audio as sounding "bassy" as 
well.  If so, it is almost definitely this adjustment - if not, it's 
probably not.

A soundcard-equipped PC can easily plot the audio response by feeding the 
receive audio into the soundcard's input and running SR5 
software(www.ar5.com to download).  Tune to an open frequency (noise) and 
run a plot.  You should definitely see an audio response that is fairly flat 
out beyond 2000hz with the 2.4 filter.  A plot of my Corsair is at 
http://www.albany.net/~bg/Audio/Corsairspectra.htm although this is slightly 
more extended due to the Inrad 2.8 filter

GL/73,

Barry  N1EU
www.albany.net/~bg


>On Sat, 12 May 2001, mike bryce wrote:
>
> > I've always been a CW op and rarely use  SSB. When I do, I get reports 
>of
> > "bassy' audio. I've tried D-104, Sure 444D and a handful of others.
>
>I bet your carrier set points are not adjusted correctly.  The D-104
>should NEVER give "bassy" audio (unless you've modified it!)  Your carrier
>setpoint could be set way up the filter curve and that would cut off highs
>and only pass lows, so the mike would not have much to do with it.
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>