I think there are adjustment pots in the ADC/DAC, R337 and R340 of the A7
section (schematic 10) that effect the meter, although it may effect the
S-Meter reading too. Best check with the factory, but it may be an easy
"fix at home" situation.
Ron
N6AHA
----- Original Message -----
From: <k3hx@juno.com>
To: <tentec@contesting.com>
Sent: Saturday, February 18, 2006 12:54 PM
Subject: Re: [TenTec] Orion meter pegging on CW TX
> OM,
>
> My concern is with the initial dit or dah, the meter needle slams
>
> against the peg and then stays there as you noted.
>
> 73,
>
>
> Tim
>
> -- "Chortek, Robert L" <robert.chortek@berliner.com> wrote:
> The needle on my Orion II goes to the peak value, whatever level that
> may be depending on the power level, and holds at that peak while I
> continue to xmit, without moving between dits and dahs. It is very nice.
>
>
> Does yours work differently?
>
> 73,
>
> Bob/AA6VB
>
> Tim Wrote: When running at indicated PWR levels above "70" the meter
> needle pegs to the right when the transmitter is keyed on CW. I'd be
> grateful to know of a damping technique to remedy this.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> ________________________________________________________________________
> Try Juno Platinum for Free! Then, only $9.95/month!
> Unlimited Internet Access with 1GB of Email Storage.
> Visit http://www.juno.com/value to sign up today!
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|