Nope. An LCW signal goes up in pitch when you increase frequency. A UCW
signal goes down in pitch when you tune up in frequency.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "John B. Egger" <john_egger@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, October 27, 2006 8:47 PM
Subject: [TenTec] UCW and LCW
> I'm a bit puzzled by these two O-2 modes. When UCW is selected, the
> lower CW sideband is audible; that is, if zero-beat is 7020, to hear the
> signal one tunes down to 7019 etc. When LCW is chosen, one must tune UP
> from zero-beat to hear the signal.
>
> Isn't this the opposite of what LCW and UCW should mean?
>
> --
> --John K3GHH
> Registered Linux User #291592
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|