TenTec
[Top] [All Lists]

Re: [TenTec] OMNI V 500 hz. filter

To: tentec@contesting.com
Subject: Re: [TenTec] OMNI V 500 hz. filter
From: ka5m@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 01 Mar 2007 18:08:03 -0500
List-post: <mailto:tentec@contesting.com>
Check the filter very carefully for cold solder joints / loose connections.  I 
had this problem once with a 500Hz filter and a quick resolder with a 25 watt 
iron fixed it. 
73,
Marsh, KA5M
 
 
-----Original Message-----
From: donjan7@earthlink.net
To: tentec@contesting.com
Sent: Thu, 1 Mar 2007 4:43 PM
Subject: Re: [TenTec] OMNI V 500 hz. filter


I have 4 filters in the 6.3 Mhz. IF: 2.4, 1.8, .5, .25.  They all work, 
but the 500 hz. has less output than the 250 hz. - even when I adjust 
the PBT and the FADE/BP controls for max gain.  Gain is probably 25% or 
so less, but definitely noticeable.  Could one of the crystals in the 
filter have drifted?  Or be bad?  I have tried "exercising" the 
connections by plugging and unplugging the filter per Don Prouty in the 
Ten-Tec service dept.  Is this a fixable problem by sending back to 
Ten-Tec?  Since their hourly rate is $60, maybe just as well to buy a 
used one for $60-70 including shipping.  Anyone have any ideas?

Thanks, Donald K6RV

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
________________________________________________________________________
AOL now offers free email to everyone.  Find out more about what's free from 
AOL at AOL.com.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>