TenTec
[Top] [All Lists]

Re: [TenTec] RF gets into computer

To: tentec@contesting.com
Subject: Re: [TenTec] RF gets into computer
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 22 Apr 2007 10:33:19 -0600
List-post: <mailto:tentec@contesting.com>
On Sun, 2007-04-22 at 16:22 +0000, John B. Egger wrote:
> John K Gotwals wrote:
> 
> >When I operate on 75 meter SSB with my Orion, my computer beeps and 
> >disconnects/reconnects my USB connected keyboard. Note that I do not have 
> >this problem on 40 meter SSB. My computer is located on the second floor of 
> >a brick house, and one end of my dipole is about 15 feet from my shack.
> >
> >>From comments made by others on this list, I may have to put RF filters on 
> >the cables and wires connected to my computer. I am contemplating the use of 
> >Amidon FT-240-77 ferrite toroids, which have an I.D. of 1.4 inches and cost 
> >$9 each. If I buy in quantities of 10, is there a cheaper source for this 
> >toroid?
> >
> >Any comments or suggestions on this problem would be appreciated. 
> >

> >  
> >
> Old thread, but something is exacerbating my problem recently. On 40m CW 
> the Orion II at full power is now QRM'ing my computer; I had to copy 
> some traffic by pen and paper this morning because of it.
> 
> Two experiments, after wrapping the keyboard cord in three Radio Shack 
> snap-on ferrite filters: (1) Moving the keyboard about 3' from the 
> Orion, instead of its usual 1', allows full power keying without 
> interference, and (2) using a dummy load on the Orion, and then on the 
> output of the MFJ 993B autotuner, allowed full power without 
> interference, with the keyboard in its normal place. (Reattaching the 
> antenna produced the QRM again.)
> 
> Any thoughts? I thought perhaps the RFI was from the Orion front panel,  
> which might explain the moved-keyboard success, and I was surprised to 
> see the problem disappear with the dummy load.
> 
> --John K3GHH
> Registered Linux User #291592
> 
Seeing the problem cured with the dummy load points to the antenna. You
need to either reduce power or move the antenna. You are getting plenty
of RF exposure that close to the antenna as the computer is detecting.
USB bandwidth includes 40 meters so a choke on the outside of the cable
may not have effect.

Look to Mouser, www.mouser.com for more toroids.

73, Jerry, K0CQ

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>