TenTec
[Top] [All Lists]

Re: [TenTec] Titan 425 troubles, R1 and blown 20a fuses

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>,n5oe@nctwb.net
Subject: Re: [TenTec] Titan 425 troubles, R1 and blown 20a fuses
From: <w4nj@tampabay.rr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 20 Jul 2007 21:34:42 -0400
List-post: <mailto:tentec@contesting.com>
YOU NEED A NEW TRANSFORMER!!

73,

CLIFF - W4NJ
---- Carlin Royal <n5oe@nctwb.net> wrote: 
> 
> I have a Ten Tec Titan 425 that I have only had myself for about 6 months 
> now. The amp when I received it had 1 bad HV capacitor in the power supply. 
> Due to lack of funds at the time I replaced the one known bad capacitor. A 
> few months later I was operating the amplifier during a cw pileup for about 
> 30 minutes, I set everything on standby and went to lunch. When I returned to 
> the shack I find the amp had blown one of the 20amp fuses in the supply.
> After checking in the PS, I found that R1 the 10ohm 25watt wire wound 
> resistor on the rectifier board had went open. I replaced the blown resistor 
> and powered the amp back up, this time again blowing a 20ampfuse and the same 
> resistor. Ten Tec advised to replace the original rectifer board with a new 
> one, (82112 rev E I beleive) since they thought some diodes were probably 
> leaking and was the cause of all my troubles. Now after replacing the old 
> rectifier board with the new one from Ten TEc, I power the amp on and it 
> blows another 20amp fuse but did not appear to fry the resistor this time. 
> Here is the main question to the list; Could I have another bad capacitor 
> that is failing under high voltage since they do not read any shorts on the 
> VOM when individually beng tested. I have on order 8 new 400uf 450v caps from 
> Newark Electronics and will be replacing them this week, but I am looking for 
> more input as to the trouble. It just seems odd to me that when sitting idle 
> for just
  3
>  0 minutes the thing went south and now I have had all this trouble. 
> Hopefully I am on the right track and it will be one of the caps in the PS, 
> but would be interested to hear any other areas that I might could check 
> within reason here on the very limited bench. Thanks for any advise/comments.
> 73  
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>