TenTec
[Top] [All Lists]

Re: [TenTec] Ham Radio Deluxe

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Ham Radio Deluxe
From: "DW Holtman" <tubestuff@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 30 Jan 2009 20:00:40 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hello,

Still cannot get the serial connection to work. Looking through the manual, 
I can find no mention and the circuit board descriptions of what circuit 
board does the interfacing with the serial cable? I want to pull the covers 
and look for loose connections etc.

Back to the wiring. I now have three different wiring configurations all 
from Ten Tec.

What I have is a 25 Pin (Radio) to a 9 Pin (Computer) wired as below.

Computer        Radio
Pin 2 ----------Pin 3
Pin 3 ----------Pin 2
Pin 5 ----------Pin 7
Pins 1, 4 and 6 jumpered (shorted) together on the computer 9 Pin connector.

Some of the documentation show no jumpers at pins 1, 4 and 6, and one shows 
jumpers only from pin 4 to pin 6? Are the jumpers necessary and in what 
combination?

Jerry, K0CQ (thank you) sent me some detailed information to help explain 
what the various pins are for, but I'm still lost. I have tried every 
combination of DTR and RTS in the software packages such as HDR.

Has anyone found hardware problems inside the OMNI causing no communication? 
I have already done a master reset with no help.

Any suggestions/help would be greatly appreciated.



----- Original Message ----- 
From: "Mike, K9UW" <k9uw@wi-net.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, January 18, 2009 6:05 PM
Subject: Re: [TenTec] Ham Radio Deluxe


> DW, I've used PCI serial cards from Byterunner on several occasions with
> excellent results.  They're cheaper than most places as well.  Their
> telephone rep told me, last time I called, that Hams were regular 
> customers.
>
> <http://www.byterunner.com/byterunner/category=2+Serial+(RS-232)+PCI-bus+cards/exact_match=exact>
>
>
> 73, de Mike, K9UW
> Amherst, WI
>
> DW Holtman wrote:
>> Tim,
>>
>> I will check tomorrow and see if  I can find a Serial Port PCI  Card. Is
>> there any drivers etc required, or is a Serial Card plug and go.
>>
>> Thank you again,
>> DW Holtman
>> WB7SSN
>>
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>