One of my neighbors is using a relatively slow (6 MHz) single core with 1
GHZ Ram, five or six years old computer.... PowerSDR does not require a lot
of computer horsepower by itself.
73 es DX,
Gary - AB9M
-----Original Message-----
From: Barry N1EU
Sent: Friday, May 13, 2011 4:25 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] O3 wish list
Yes, but aren't many folks going to need a computer upgrade to
efficiently run PowerSDR if they have older single core cpu's?
Barry N1EU
On Thu, May 12, 2011 at 10:57 PM, CSM(r) Gary Huber <glhuber@msn.com> wrote:
Well, 1st off you'd have to go for the IF.... and that’s why I prefer the
N4PY sub-r mod and the FLEX-1500 running in panadapter mode using
PowerSDR.
$650, ten minute (no solder mod) and away you go, without risking your
expensive radio to a soldering iron.
73 es DX,
Gary - AB9M
-----Original Message-----
From: John Molenda
Sent: Thursday, May 12, 2011 9:50 PM
To: k9yc@arrl.net ; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] O3 wish list
On 5/12/2011 10:35 PM, Jim Brown wrote:
On 5/12/2011 3:35 PM, CSM(r) Gary Huber wrote:
At $650, the FLEX-1500 is about the cheapest panadapter one can buy.
The P3 costs $700 as a kit, which takes about an hour to build. It's a
pre-tested board for which you screw together a simple enclosure and
mount a few connectors. Yes, it can be easily set for a wide range of
IF frequencies via a menu setting.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
But how does it work with Ten Tec orion II ?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|