TenTec
[Top] [All Lists]

Re: [TenTec] Re. [Ten Tec] Grounds and balanced fed verticals

To: <k9yc@arrl.net>, "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Re. [Ten Tec] Grounds and balanced fed verticals
From: "Jerry Haigwood" <jerry@w5jh.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 27 Jan 2012 15:34:52 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Jim,
     When I visited the 50,000W AM station WRAL some 35 years ago, their
coaxial feedline was home brewed.  There were a set metal pipes about 1.5
inch diameter cemented into the ground and sticking up 3 feet or so.  A 2x4
8ft long was connected between the pipes on top of pipe flanges.  About
every 4ft was a ceramic standoff holding a 1 inch diameter copper pipe
(center conductor).  Wrapped around the pipe and spaced about 3 inches away
from it was copper sheathing nailed to the 2x4.  The whole thing looked like
a 200ft long mail box!  I asked the chief engineer what the impedance was
and he said he had never measured it but the original data taken at the time
the station was built, said it was 63 Ohms.  He said it was about 40-45
years old and stated that the antenna current was still the same as day one.
It was obviously very well built coax....
Jerry W5JH

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jim Brown
Sent: Friday, January 27, 2012 3:09 PM
To: tentec@contesting.com
Subject: Re: [TenTec] Re. [Ten Tec] Grounds and balanced fed verticals

On 1/27/2012 11:41 AM, Steve Hunt wrote:
> Jim,
>
> What "bugs" me most about this issue is that it isn't Rocket Science -
> simple application of Ohm's Law will give you the answers.

Yes

> Some may think that's an insignificant difference and that we are
> "nit-picking"; but now imagine you are running a long length of that
> ladderline at high VSWR based on an Antenna Book loss prediction of 2dB
> - would you be happy if you discovered that the real loss was at least
> 4.8dB? Or that what you thought was a 4dB loss was actually nearer 10dB?

Exactly my point as well.  One option that smart engineers always 
consider for very long runs are open wire lines. Anyone who has had the 
opportunity to visit one of the WW!! vintage HF broadcast and 
communications stations or a high power AM broadcast transmitter has 
seen LOTS of open wire lines feeding rhombics, Sterba curtains, vertical 
radiators. Some are/were balanced, and some are/were in a coaxial 
configuration. They are typically supported on rigid poles with a 
U-shaped bracket and insulators at the top. In a typical coaxial 
configuration, there might be four closely spaced parallel wires 
functioning in parallel as the center conductor and four or more wires 
at much wider spacing surrounding the center conductor as the shield.

73, Jim Brown K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>