TenTec
[Top] [All Lists]

Re: [TenTec] ufer ground?

To: tentec@contesting.com
Subject: Re: [TenTec] ufer ground?
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 12 Aug 2013 09:36:20 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 8/12/2013 7:03 AM, GARY HUBER wrote:
My previous work place used a Ufer ground mat (basement floor rebar of all buildings of the complex) bonded to building steel (and pilings) with copper grounding bars bonded to them. An external ground ring with ground rods was bonded to each vertical building steel member, with air terminals (on each building roof) bonded to building steel. Copper grounding bars in 14th story equipment room were connected to the ground mat with a 250 foot run of a pair of 400 MCM cables. The electrical service neutral and mechanical ground were also referenced to the ground mat.

Everything sounds exactly right about that except the separate 250 ft run, which is certainly legal, but would just as well be done to building steel on the 14th floor. The virtue of going to building steel is that there are many paths in parallel, and they are all bonded together at multiple points, which does two very important things. The paths are in parallel, thus minimizing the inductance to earth (a much greater component of the impedance to earth than the resistance), and the bonds between them at adjacent points minimizes the potential difference between adjacent points. Indeed, bonding all the grounds is REQUIRED, not optional.

73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>