Jim, if you have trouble with BCI on your analyzer, the BCI is gonna give
you trouble on the air too. In that case I recommend investing in a good
Highpass Filter like a Dunestar HPF-400 or similar. Insert it in the coax
and then attach the analyzer. The analyzer will then work ok.
The best antenna most of us can deploy is an Inverted-L.
I wasted 20 years trying to get a low dipole to work on 160m.
Hardly worked much outside of my own country (Germany) during that time.
Finally tried the Inverted-L and immediately began working the world on
160m.
You don't even need a tuner. You can easily match the antenna right at the
base.
The only thing you have to accept in your own mind is that you have to have
a dedicated antenna, just for 160m.
The biggest mistake people make is to try and bend something so that it
covers 160m and a bunch of other bands.
Waste of time if you're goal is really to have a big signal on 160m.
My 160m Inv.-L is resonant on 1.850 Mhz. for CW. I switch in a capacitor at
the feedpoint to raise it 50 kHz for SSB.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Jim GM
Sent: Wednesday, November 06, 2013 8:17 PM
To: TenTec-request
Subject: Re: [TenTec] 160 M antenna
Rick, I like your answer. I agree with the others too.
Make the external tuner for 160, and 80 and auto tuner, with a remote bypass
so you can use the tuner in the sack for the other bands. Mount the
160/80 tuner out side close to the radial field.
160M is a pain in the but, to get it working. BCI messes up my analyzer so
it is a work in progress and trial and error. Just too close to the
transmitter sites.
--
Jim K9TF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|