Dan,
I have just installed an additional 8 ft. ground rod. I used a 5/8 copper
clad steel ground rod from Home Depot.
It went in very easy in caliche/limestone base below the top soil. I used a
small electric jackhammer. Just remove the hammer bit and place the driver
over the ground rod. Most of the driving was accomplished with just the
weight of the Jackhammer. It took a little manual force to get thru a rocky
area about 4 ft down. Otherwise an effortless way to sink the rods.
73's Jim
W5IFP
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com]On Behalf Of Dan Bookwalter
> Sent: Tuesday, November 30, 2010 11:43 AM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Ground Rods
>
>
> Ok , i have seen several discussions regarding what people are
> using for ground
> rods.... some use actual 5/8" ground rods , while others use 1/2"
> copper pipe ,
> thoughts on which is better ?
>
> also i was thinking about using 4ft ground rods instead of 8
> footers , but use
> twice as many of them , it is much easier to drive the 4 footers
> , thoughts ?
>
> thanks
>
> Dan N8DCJ
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|