Yes, you are missing something. As I pointed out, this is incorrect
information. During SSB DVK, I know
of at least three ways to control PTT:
a. through the W5XD+ keyer/control.
b. through LPTport/CommPort RTS.
c. by command on the rig control port.
I have tested all three here on the 756PRO including the somewhat bizarre
case of
rig control (without PTT) control being on COM1 and controlling PTT on COM5.
All cases worked. In addition, the signals used were verifying using an
RS232 display
board.
73,
Mike WA0SXV
----- Original Message -----
From: "Les Peters" <les.peters@ne.arris-i.com>
To: "Wayne Wright" <w5xd@alum.mit.edu>
Cc: "Richard B Drake" <rbdrake@erols.com>; <writelog@contesting.com>
Sent: Monday, October 09, 2000 10:11
Subject: Re: [WriteLog] RIGBLASTER and DVK
>
> It appears the only way that you can control a PTT line via a com port is
if
> your rig has an RS232 interface whose command set supports PTT operation
(i.e.
> not via the mic connector).
>
> In version 10.19 there are no check boxes in the port setup menu under
"DVK"
> for any com ports, how would you select DVK rather then RIG or CW. Does
it
> matter what's selected? I have talked to K1UHF who has verified that the
> control of PTT does not work for controlling his Rigblaster (DVK) unit.
It
> appears the only way to control a DVK for WAV file transmission is via the
> parallel port. Am I missing something?
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|