Amps
[Top] [All Lists]

[AMPS] Safety resistor

To: <amps@contesting.com>
Subject: [AMPS] Safety resistor
From: rakefet@rakefet.com (Vic Rosenthal)
Date: Mon, 11 Oct 1999 11:09:17 -0700
In the common circuit used for GG triode amplifiers that separates the B- from
ground in order to allow for convenient plate and grid current metering, there
is a 'safety resistor' from B- to ground.  

Most designs seem to use a value like 10 or 20 ohms.  As G3sek
<http://www.ifwtech.demon.co.uk/g3sek/> points out, if you use the 'voltmeter
method' to measure grid current, the high value of the shunt resistor requires a
higher value for the safety resistor (he suggests 1000 ohms) to keep the grid
metering accurate.

My question is:  What malfunction is this 'safety resistor' protecting us
against?  What could happen if it were omitted or opened in service?

73,
Vic, K2VCO
Fresno CA

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>