Amps
[Top] [All Lists]

[AMPS] Millen HV Connectors Factory Pricing

To: <amps@contesting.com>
Subject: [AMPS] Millen HV Connectors Factory Pricing
From: philk5pc@tyler.net (Phil Clements)
Date: Tue, 20 Nov 2001 17:53:43 -0600

> Absolutely stay away from the lesser-rated Millen connectors in any HV
application.  The first-generation Alpha amplifiers used
> these connectors between the P.S. compartment and the R.F. deck.  Even with
new connectors and 4 KV applied, all bets are off.  I
> recall trying to localize a HV glitch problem in one of these amps and after
unsuccessfully trying everything else, I decided to
> bring-up the amp at low voltage (2.6 KV) with the top cover off and
subsequently noted a blue corona around the connector.  I
> ditched the Millen connector in favor of a glazed-porcelain feedthrough and
have never experienced a single problem since.  Later
> Alpha amplifiers simply passed the silicone HV wire through a chassis hole and
rubber grommet.  This solved the flashover problem,
> but made servicing difficult.  It's a shame that these connectors were
manufactured by Millen: Every other item in their extensive
> product line was designed and produced to perfection.

I have been down that road also, Paul! I solved the problem years ago when I
started mounting the
socket to the chassis a bit differently. I drill a hole in the chassis slightly
smaller than the width of the
socket. I then fashion a rectangle of  1/4" plexiglass slightly larger than the
dimensions of the socket. A
hole is then drilled in the center of the plexiglass slightly larger than the
shaft of the socket. Then
2- #6 holes are drilled through the plexiglass and chassis to match the mounting
holes on the socket.
This gives C. 1/4 inch separation between the socket and chassis. I have had
zero failures since I
changed the mounting scheme. Every failure previous to the change was right
where yours was;
where the shaft of the socket passes through the chassis. I would never dream of
pushing the
ratings above 6 kv. on the red or black units. The yellow units should never be
used > 1 kv,
IMO.

(((73)))
Phil, K5PC





--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>