Amps
[Top] [All Lists]

Re: [Amps] 8877 Test

To: Amps@contesting.com
Subject: Re: [Amps] 8877 Test
From: TexasRF@aol.com
Date: Mon, 14 Feb 2005 10:38:27 EST
List-post: <mailto:amps@contesting.com>
Hi alex and all,
This is a true story: About a year ago I was given an unused 8877 that was  
about 20 years old. After all the warnings about firing up old tubes, I used my 
 newly acquired solid state 0 to 10kv module and trusty Triplett 630 VOM to 
test  it for leakage. It showed leakage from plate to grid beginning at about 
600vdc.  I ran the filament only for about a week, testing leakage daily. The 
leakage  voltage slowly increased day by day and after a week had reached about 
5kv. I  know really good tubes are better than this but decided to stop the 
burn  in.
 
At this point it was installed in a 2m PA and fired up at half plate  
voltage, about 2000vdc. It seemed to operate ok at that voltage so after about  
an 
hour the plate voltage was increased to 3000vdc and then the normal 4000vdc.  
There was an immediate "incident" that blew the 2A fuse in the B+ circuit. The  
fuse was replaced and the amp has been performing perfectly since then. 
 
I am tempted to retest the tube leakage again but it is just way too much  
trouble to disassemble the cavity to free the tube for a test.
 
Since then I have tested an old TWT this way and found the same 600vdc  
starting point for leakage. After only one day with the filament only, this 
tube  
would then go all the way to 8kv before onset of leakage. The tube is rated at  
4kv so it probably will be ok when I finally get around to testing it with  
rf.
 
The moral of this? I will always test tubes for leakage, old or new, in the  
future, before use. I can see that it will prevent some of the big KAPOWS! 
seen  in the past.
 
73,
Gerald K5GW
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>