Absolutely. My Henry 3K-A is spec'ed at 2000W PEP Output right in the manual.
It has ~4000V unloaded (3750 or so loaded) on the plates. With the fresh RF
Parts ZGs, I got every bit of that with 100W drive. The amp is specified up to
150W drive, which my new rig will do, but I haven't tested it yet. I will this
weekend and let you know (into a dummy load, of course).
Joe, N3JI
Jason Buchanan <jsb@digistar.com> wrote:
> if your Eimac tube outputs 1 KW or so, that should mean
> your good to go.
Ye cats - 1KW from a single 3-500Z?
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---------------------------------
Yahoo! FareChase - Search multiple travel sites in one click.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|