Re: [Amps] QRO Parts

["Jim Tonne" <tonne@comcast.net>]

"Now the question i asked was where to get information 
regarding the plate
impedance at 3.8KV. Im sure there must be a chart/graph to 
figure this out.
Mike
KC7NOA"


For a stand-alone PI and PI-EL network
calculator   *with analysis*   don't overlook
http://tonnesoftware.com/piel.html

Not only does the design based on the usual
entries but also gives you transmission and return
loss plots as well as volts across and current
through each component.

- Jim   W4ENE


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps