Amps
[Top] [All Lists]

Re: [Amps] GS23B Plate load resistance for HF

To: <TexasRF@aol.com>, <dezrat1242@yahoo.com>, <amps@contesting.com>
Subject: Re: [Amps] GS23B Plate load resistance for HF
From: "Jeff Blaine" <keepwalking188@yahoo.com>
Date: Thu, 31 Oct 2013 11:38:33 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Lot of names.  Hi-pot value.  Break down voltage.  Leakage test threshold.  

It’s the voltage where the tube starts leaking current.

73/jeff/ac0c
www.ac0c.com 
alpha-charlie-zero-charlie



From: TexasRF@aol.com 
Sent: Thursday, October 31, 2013 11:37 AM
To: keepwalking188@yahoo.com ; dezrat1242@yahoo.com ; amps@contesting.com 
Subject: Re: [Amps] GS23B Plate load resistance for HF

OK, I bite: what is BDV?

73,
Gerald K5GW



In a message dated 10/31/2013 9:33:39 A.M. Pacific Daylight Time, 
keepwalking188@yahoo.com writes:
  What BDV does the GS35b typically show on "good" tubes?

  73/jeff/ac0c
  www.ac0c.com
  alpha-charlie-zero-charlie

  -----Original Message----- 
  From: Bill Turner
  Sent: Thursday, October 31, 2013 10:14 AM
  To: Amps
  Subject: Re: [Amps] GS23B Plate load resistance for HF

  ORIGINAL MESSAGE:          (may be snipped)

  On Thu, 31 Oct 2013 09:02:26 -0000, GM3SEK wrote:

  >There is a major difference between the Western high-mu triodes and the
  >Russian family of low-mu triodes.  High-mu triodes like the 8877 are
  >designed to deliver good gain and efficiency at relatively low anode
  >voltages, but the GS35b requires much higher voltages. Performance at
  >anything below 3.0kV is sure to be disappointing, and the best overall
  >performance is generally obtained at about 3.5kV on load, rising closer
  >to 4.0kV off-load. Some specimens will tolerate higher voltages but with
  >a rapidly increasing risk of arcing.
  >
  >
  >73 from Ian GM3SEK

  REPLY:

  That's good to know Ian, but the spec sheet I have says the max DC is 3kV
  and the max instantaneous peak is 6kV. I'm sure those values can be exceeded
  a certain amount but one would be getting into risky territory. On the other
  hand, the tubes are so cheap it might be worth the risk.  I know some folks
  are running them at 4kV with no apparent problems.

  Thanks for the info.

  73, Bill W6WRT
  _______________________________________________
  Amps mailing list
  Amps@contesting.com
  http://lists.contesting.com/mailman/listinfo/amps 

  _______________________________________________
  Amps mailing list
  Amps@contesting.com
  http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>