Someone spoke about crimpers and connectors from RF Industries. I've
been on their web page and they have a very large selection of
commercial grade connectors and Kits that come complete with the tool
and die. They also sell the crimping tool separately for $67.56 and a
die for RG8, 213, 214, and a Belden coax that I did not record in my
notes which one it was, anyway that die sells for $32.29. They also
sell a kit with the tool and about 6 different dies for $268.00
They have a very large selection of connectors and their UHF connector
sells for 2.51 each. I was also advised that if I went to one of their
distributors the price should be a bit less than what they sell them for.
Hope this helps.
73 Pete N4KW
On 11/13/2013 1:21 PM, Paul Christensen wrote:
I would like that have info too. I spend WAY too much time soldering
PL-259s. Also, what about stripping the cable for installing the
crimp PL-259s? is there a tool for that? If so, how
necessary/important is it?
Pretty important. I use several Paladin 2 and 3 level strippers.
Check, and then re-check the stripper model against the coax type and
crimp connector used.
Paul, W9AC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|