OK then what would be a better resistor for the Titan to fit the Titan as a
direct replacement? Resistance, Wattage, Part #, Manufacturer, Supplier.
Doug
"Political correctness is a weapon used to silence people who tell the
truth" - Ayaan Hirsi Ali
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of gudguyham---
via Amps
Sent: November-16-17 10:18 AM
To: ve5ra@sasktel.net; amps@contesting.com
Subject: Re: [Amps] Glitch resistor + fuse?
The resistor used in that Ten Tec isn't the best choice. Over time the
ouert coating of the resistor flakes off and exposes the wire winding to
dust etc. and unless it is kept clean or replaced it can cause a problem
later on. The proper resistor has a hard durable enamel coating that won't
flake off.
-----Original Message-----
From: Doug Renwick <ve5ra@sasktel.net>
To: amps <amps@contesting.com>
Sent: Thu, Nov 16, 2017 11:08 am
Subject: Re: [Amps] Glitch resistor + fuse?
Correction:
The Tentec Titan amp uses a single 10 ohm 25 watt Ohmite 0610 part #
L25J10RE.
Doug
"Political correctness is a weapon used to silence people who tell the
truth" - Ayaan Hirsi Ali
-----Original Message-----
I'm pretty sure they are .82 Ohms at 2 watts. There are lots of them on EBay
for free shipping and small quantities.
73
Jim W7RY
-----Original Message-----
<The Tentec Titan amp uses a single 10 ohm 25watt ohmite.
<Doug
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|