> My problem regarding two or three tone tests is that my rigs all have
> comparably terrible IMD. Several Ten Tec rigs, and a JRC
> NSD-515. None of
> them have spectacular IMD performance. How do you get around these
> limitations?
Two separate CW transmitters combined with high isolation between the two,
or two separate signal sources combined into an external low-IMD (typically
class A) amplifier used as a driver.
The former is typically the lower-cost solution as high-power low-IM
wideband amplifiers are not cheap, even on the used market. But for
high-gain solid-state amplifier designs, the latter can be viable from a
cost standpoint when only need a few watts of drive into the DUT is
required.
--- Jeff WN3A
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|