I think the replies to this missed the issue.
On my Thinkpad with WIN98 when one boots to DOS, the entire DOS screen
occupies a block in the center of the screen. I want DOS to occupy
the entire screen just like it does on a normal monitor. It
apparently is putting the 640x200 DOS screen in the center of the
1024x768 SVGA display.
de Brian/K3KO
Hank Kohl K8DD wrote:
>
> At 7/1/02 10:15 AM +0100, Buffham, Ian wrote:
> >I have a DOS version of CT which works just fine under Windows 95. I have
> >just acquired a laptop for use in a contest which has Windows 98. CT runs
> >OK with this but the problem is that the display only occupies about one
> >third of the screen. Does any one have any ideas as how to make it occupy
> >the full screen?
> >Regards Ian G3TMA (Also G3TMA@aol.com)
>
> From a DOS window, press ALT-Enter for full screen mode.
> Although I'd run it from a Command Prompt (DOS Mode- press F8 during boot).
>
> 73 Hank
>
> _______________________________________________
> ct-user mailing list
> ct-user@contesting.com
> ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
|