Karlnet
[Top] [All Lists]

RE: [Karlnet] PRISM II 100mW card and Karlnet TC V4.02

To: "'karlnet@WISPNotes.com'" <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] PRISM II 100mW card and Karlnet TC V4.02
From: Dan Metcalf <danm@suncorstainless.com>
Reply-to: karlnet@WISPNotes.com
Date: Fri, 10 May 2002 14:24:56 -0400
List-post: <mailto:karlnet@WISPNotes.com>
Anybody else see this?


Dan Metcalf
Wireless Broadband Systems
dan.metcalf@wbsysnet.com
781-658-2075
www.wirelessbroadbandsystems.com

-----Original Message-----
From: Norm Young [mailto:npyoung@applegatebroadband.net]
Sent: Friday, May 10, 2002 12:29 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] PRISM II 100mW card and Karlnet TC V4.02

I'm going to pull this PRISM II 100mW card, as I've discovered that the
reporting of the signal strength at the AP (PRISM II, Karlnet TC) is
accurate---and extremely low.   I'm seeing signal strengths that are a good
10dB below what they were with the Orinoco radio in place and all other
factors equal/similar.  The transmit power is as expected, 5dB above the
Orinoco radios, but the receive sensitivity is, to say the least, very
disappointing.

I'll report the findings with the Orinoco radio slotted, and perhaps it will
reveal some other factor is at work, but for now, the PRISM II card is a dud
on the receive sensitivity side.  (Also the crash on reboot "feature".)


Norm

----- Original Message -----
From: "Tony " <tonylist@wwwbiz.com>
To: <karlnet@WISPNotes.com>
Sent: Thursday, May 09, 2002 8:39 AM
Subject: RE: [Karlnet] PRISM II 100mW card and Karlnet TC V4.02


> Dong
>
> You have this card! Its the one we sent you for testing :)
>
> Sincerely
> Tony Morella
> Demarc Technology Group
> Office: 908-996-7995
> Cell: 908-246-9170
> Fax: 908-847-0202
> email: tony@demarctech.com
> http://www.demarctech.com
> Wireless Solution Provider
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Support
> Sent: Tuesday, May 07, 2002 1:18 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] PRISM II 100mW card and Karlnet TC V4.02
>
>
> Norm,
>
> We see this problem with some of the higher power radios in the AP-1000
> and the RG-1000.  Those pieces of hardware were made for the 32mW radios
> and they will act funny with the 100mW and 200mW radios coming out. I
> have not seen the radio you are using, but if you want to send one in
> for testing we'd be glad to look at it for you.
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

<Prev in Thread] Current Thread [Next in Thread>