Like I said though...if I enable NAT and the DHCP server...it works fine.
I even tried two different interfaces on the AP-1000...no go.
Bridging fails, NAT works fine. I've gone over and over the configs.....
This is the only 4.02 RG that I have...the others are 3.88 and this is the
only one that is exhibiting this problem. Anyone have knowledge of version
incompatibilities?
My AP-1000 is set to ISPbase.
-bob
----- Original Message -----
From: "Roger Boggs" <rogerboggs@att.net>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, October 15, 2002 1:36 PM
Subject: Re: [Karlnet] 4.02 RG won't bridge to a 3.88 AP-1000
>
> After you've double-double checked the IP addresses/subnet masks/gateways
and
> all that stuff, double-triple check the system passphrase and set it to
> something
> that you absolutely know on both ends to the be the same. Assume nothing.
>
> This has stopped an awful lot of links from working in the past.
>
> Good luck. It's gotta be something fairly simple, Bob.
>
>
> At 10:44 AM 10/15/02 -0500, you wrote:
> >I've got a 4.02 RG-1000 that absolutely will not bridge to my 3.88
AP-1000.
> >The RG links up and everything appears to be functional but I cannot ping
> >anything...it is as if the RG just isn't passing anything. I ran a
sniffer
> >and my machine is arping but I never get a arp response.
> >
> >If I enable NAT on the RG, things work fine. Anybody else see anything
like
> >this?
> >
> >-Bob
>
> Roger Boggs
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|