These are shipping?
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Norm Young
> Sent: Thursday, June 26, 2003 9:33 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] First install of Ubicom-based CPE...
>
> I've got a couple of Ubicom boards enclosed in the AntennasAmerica
19dB
> panel/enclosure, and I'm trying to set one up for the first time.
Seems
> simple enough, with a web interface, can't mess it up, right? :)
>
> However, after installation in a place I know has good signal (-84dBm)
via
> a
> Lucent Silver using the XP driver, I cannot get a signal. There are a
> couple of possiblities, I think: 1) Wrong RF connector, or 2) the
Ubicom
> has
> much, much less RF sensitivity than the Lucent card. (Seems unlikely.)
>
> Since I've had to swap these boards out, (got 802.11b instead of TC
boards
> by mistake) there is some question on which of the two RF connectors
to
> use
> on the board. I've currently got it in the connector closest to the
power
> connector. Swapping it over to the other seemed to make no
difference.
>
> I've set the Ubicom to the base station channel, (auto
selection/scanning
> doesn't work) but it reports nothing. The system passphrase is set
> correctly, but I don't see a place to enter the Network ID number like
you
> have to with the SR-4000.
>
> Anyone else had a setup experience with this hardware?
>
> Norm
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
---
[This E-mail scanned for viruses by Declude Virus]
|