So far so good!
We should be rolling out product in the next 3 weeks or so!
Kevin
************************************************
Kevin R. Knuth
Business Development Manager
(260) 424-9690 - Regional Office
(818) 760-1000 x 233 - Corporate Office
kknuth@ai-wireless.com - Email
www.ai-wireless.com - Web
************************************************
The information contained in this e-mail and its attachment(s), if any,
are confidential and intended only for the named recipient(s). This
message and its attachments shall not be discussed, reproduced,
distributed, or retransmitted without the prior written consent of
Associated Industries.. If you are not the intended recipient, please
contact the original sender and destroy all copies of the original
message.
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Dan Metcalf
Sent: Sunday, April 18, 2004 2:52 PM
To: 'Karlnet Mailing List'
Subject: RE: [Karlnet] New repeater WIPOP has bad ping/jitter.
Hey Kevin, how are things at the new job?
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Kevin Knuth
> Sent: Sunday, April 18, 2004 2:55 PM
> To: 'Norm Young'; 'Karlnet Mailing List'
> Subject: RE: [Karlnet] New repeater WIPOP has bad ping/jitter.
>
> Norm,
>
> I know sometimes this sounds redundant- but it does help narrow it
down
> if you use the ping fill test and ONLY check on segment of a link at a
> time. This really helps isolate the problem.
>
> Kevin
>
> ************************************************
> Kevin R. Knuth
> Business Development Manager
> (260) 424-9690 - Regional Office
> (818) 760-1000 x 233 - Corporate Office
> kknuth@ai-wireless.com - Email
> www.ai-wireless.com - Web
> ************************************************
>
> The information contained in this e-mail and its attachment(s), if
any,
> are confidential and intended only for the named recipient(s). This
> message and its attachments shall not be discussed, reproduced,
> distributed, or retransmitted without the prior written consent of
> Associated Industries.. If you are not the intended recipient, please
> contact the original sender and destroy all copies of the original
> message.
>
>
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Norm Young
> Sent: Sunday, April 18, 2004 12:23 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] New repeater WIPOP has bad ping/jitter.
>
> I've recently added a KN-205/KarlBridge/Router (v4.44-02-020917
knrgotcn
> SN-xKNRG+*********458 V4.35) to our network, using it as a
> repeater/secondary WIPOP to fill in an area that had no coverage.
>
> One of the radios is set up to be a satellite, communicating with the
> main
> WIPOP, the other in PtMP/ISP Basestation to service the unserved area.
> The
> satellite is on CH1, the PtMP is on CH7. Signal strength back to the
> main
> WIPOP is very good, that to the one existing (test) client on the
PtMP
> interface is marginal with S/N ratio of 10-12dB.
>
> The whole network is bridged. I've set up a new IP subnet for this
> repeater, with the idea of moving to routing, as I'm going to have
> traffic
> for this area that needs to go only to this repeater, but I haven't
> implemented it yet. The whole network is running v4.44, and is a mix
of
> older RGs and a range of KN-50's/Ubicoms using firmware from
> v1.00-00-052215
> to 1.10-00-101315.
>
> The throughput is good, the ping times and jitter are unacceptably
bad.
> Pings to the repeater from other clients on the same main WIPOP are
> about
> normal, 25-100mS range, with most in the 20mS area. Pings to the
> repeater
> from the backhaul at the main WIPOP are 11mS-50mS, most being in the
low
> teens.
>
> However, pings through the new repeater to the one client on the PtMP
> (CH7)
> interface are simply awful. From the main WIPOP backbone they are
from
> 14mS-500mS, with most being around 200mS. Pings back from the client
> are
> just as bad. Pings from one of the Ethernet interfaces on the
repeater
> back
> to the main WIPOP also are rough, with lots of latency and jitter.
>
> Anyone have any comments on what could be wrong here? I'd say signal
> strength, but I happened to notice these jitter/latency issues with
the
> system while it was burning in on the bench, as well.
>
> Norm
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]
>
--
[This E-mail scanned for viruses by Declude Virus]
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|