Bill Turner <dezrat1242@yahoo.com> wrote ..
> ORIGINAL MESSAGE:
> On Fri, 01 Feb 2013 19:52:18 -0700, Lee wrote:
>
> >
> >I've tried using a scope with my Kam+ and the scope with MMTTY. Neither one
> >gives a perfect "+" (crosshair) indication. I'm wondering why that is so.
> >Without a perfect crosshair pattern it would be difficult to get right on
> >frequency.
>
> REPLY:
> If the crosshairs are there but not at a 90 degree angle, check your tones
> setting. Mark should be 2125 and space should be 2295.
>
> You will occasionally come across a station using 200 Hz shift instead of
> the standard 170 Hz. Those will not be at 90 degrees. Just split the
> difference and it should work unless your RX bandwidth is REALLY narrow,
> which it probably isn't.
>
> Bill, W6WRT
I only use FSK but the Mark is set for 2125 Hz in the Kenwood TS2000 with a
170 Hz shift and normal polarity. I've seen this problem with my TS450 and
Icom706 also. I thought that it was a problem with the scope mod I did on the
Kam+ until I saw the same thing on the MMTTY scope.
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|