www.keyspan.com has a 4 port USB to serial converter.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "George" <goofyham@highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, May 21, 2007 7:50 AM
Subject: Re: [TenTec] (Orion) firmware update with serial port-less computer
> I just bought a new mother board at Dayton. I knew that it did not have
any
> COM ports. I need 4 com ports to run my hamshack, O2, rotor, packet, etc.
> What is the best way to get 4 com ports, board or 4 individual USB to com
> converters? If I go with the individual converters I'll need a USB
expansion
> board.
> Suggestions?
> Thanks.
> George W2YJ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|