| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] rx 366 |
| From: | John Molenda <cdistflatfoot@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 04 Jun 2012 18:19:28 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
On 6/4/2012 5:58 PM, Barry N1EU wrote: So I am getting that the General coverage Reciver in the RX366 is as least as good as the one in the Eagle . Am I assimilating this information correct ? If the GC rx is as good as the Eagle I will think about getting one . Are there any roofing filters that will assist the RX366 in tuning or listening to General coverage receive? thanks John kb2hukOn Mon, Jun 4, 2012 at 9:16 PM,<kc9cdt@aol.com> wrote:I was told that it is GC, but the original second RX was a little better in that mode..I suspect the RX366 is actually a BETTER gc rx in all respects than the original except for out of band rejection. That's also assuming you have the appropriate roofing filter installed (original didn't need roofing filters). But I could be wrong. Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] rx 366, Barry N1EU |
|---|---|
| Next by Date: | Re: [TenTec] rx 366, Barry N1EU |
| Previous by Thread: | Re: [TenTec] rx 366, Barry N1EU |
| Next by Thread: | Re: [TenTec] rx 366, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |