On 6/4/2012 3:38 PM, Carl Moreschi wrote:
> Yes, that is correct. My N4PY Orion software has a setup to run the 366
> as VFO A for Panadpater use.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 6/4/2012 1:46 PM, John Molenda wrote:
>> On 6/4/2012 5:47 AM, Barry N1EU wrote:
>>> No on both counts. I believe the 9Mhz out uses the existing "spare"
>>> connector and a pluggable jumper between RX366 and that connector.
>>>
>>> 73,
>>> Barry N1EU
>>>
>>> On Mon, Jun 4, 2012 at 1:44 AM, John Molenda<cdistflatfoot@gmail.com>
>>> wrote:
>>>> Hello, I would like to know if the new Rx 366 board mod takes away
>>>> general coverage receive from the radio. Does the radio need to be sent
>>>> back to TT for the 9 Megahertz out jack mod ? thanks John Molenda
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> OK so if we were to hook up to a pan adapter it would only be reading
>> what is on Rx 2or vfo 2 correct ?
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
Thank you . I am considering it I just do not want to give general
coverage. John kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|