Yes, that is correct. My N4PY Orion software has a setup to run the 366
as VFO A for Panadpater use.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 6/4/2012 1:46 PM, John Molenda wrote:
> On 6/4/2012 5:47 AM, Barry N1EU wrote:
>> No on both counts. I believe the 9Mhz out uses the existing "spare"
>> connector and a pluggable jumper between RX366 and that connector.
>>
>> 73,
>> Barry N1EU
>>
>> On Mon, Jun 4, 2012 at 1:44 AM, John Molenda<cdistflatfoot@gmail.com>
>> wrote:
>>> Hello, I would like to know if the new Rx 366 board mod takes away
>>> general coverage receive from the radio. Does the radio need to be sent
>>> back to TT for the 9 Megahertz out jack mod ? thanks John Molenda
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> OK so if we were to hook up to a pan adapter it would only be reading
> what is on Rx 2or vfo 2 correct ?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|