That was one of the first things I tried - when that didn't work, I looked
at the schematics of the Omni VI and Paragon II. Even though they both have
the DB-25 Accessory Connector, they are wired differently.
On the Omni VI, there is 5 VDC available on pin 16 and two lines that the A
and B outputs from the encoder connect to.
On the Paragon II, I am not seeing 5 VDC or the A/B encoder pins. There are
several NC pins on the Paragon II connector.
The scanned copy of the Omni VI manual is fuzzy - I'm having a hard time
following where the A/B encoder lines run to.
That is where I am now - not even sure if the same scheme is followed
between the two radios as far as encoder operation.
Still in R&D mode....
Steve, N0CZV
Attica, Ohio
n0czv@frontier.com
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Mike Bryce
Sent: Friday, November 08, 2013 10:07 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Paragon II and 301 Remote
Did you try a different speaker?
Mike Bryce, WB8VGE
the heathkit shop
SunLight energy systems
J e e p
o|||||||o
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|