Yes the 301 knob will work with the Paragon II.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 11/7/2013 11:37 PM, Steve Garwood wrote:
Hello!
Is there a way to set up the Paragon II to use the 301 Remote Tuning Knob?
I ran across information on a 301 "kit" that Ten Tec came out with around
1999, in the text, it shows that the Omni 5, 6 and 6 Plus along with Paragon
II would work with this kit.
I have not located the actual document or any other information on this.
I'm wondering if anything needs set up in the radio as far as the Serial
Interface on the radio that I am continuing to read, or any wiring changes
to the 301 unit itself?
More questions than answers at this point!
Thanks!
73,
Steve, N0CZV
Attica, Ohio
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|