Mike,
I tried several speakers first, from a four inch to an 8 inch bass reflex.
Same results - the 301 had no function.
When I look at the schematic on the Paragon II, the DB-25 connector does not
have +5VDC showing, I can bring that to the connector. The A/B pins don't
look to be supported on the Paragon II, at least not by name on the print.
I need to trace what the A/B pins hook to in the Omni VI and see if I can
duplicate that on the Paragon II....
Steve, N0CZV
Attica, Ohio
n0czv@frontier.com
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Mike Bryce
Sent: Friday, November 08, 2013 10:40 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Paragon II and 301 Remote
Steve,
get +5 to it
then use you scope on the "A" output.
with each turn, you should see a square wave as the encoder sends out a
quadrature pulse. This pulse will be 90 deg out of phase with the "B"
output.
that way the logic knows what way the encoder is turning
you should see both quadrature pulses as you turn the knob, if you use both
channels of your scope.
Not sure, but if the pulses look a bit fuzzy, you might need a 10K pull up
on the output to square 'em up
But I'd try another speaker first
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is never
sure.
On Nov 8, 2013, at 10:32 AM, Steve Garwood <n0czv@frontier.com> wrote:
> Carl,
>
> I had read that in archives, but I have not found any original
> documentation. The connectors are wired differently - my first fail
> point was not having 5 VDC on the encoder. My assumption is that the
> Paragon II will need lines added to support the 301. Searching for
> additional information now.....
>
> Steve, N0CZV
> Attica, Ohio
> n0czv@frontier.com
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Carl
> Moreschi
> Sent: Friday, November 08, 2013 7:41 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Paragon II and 301 Remote
>
> Yes the 301 knob will work with the Paragon II.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|