Topband
[Top] [All Lists]

Re: Topband: Covered /bare antennn wire

To: "Bruce" <k1fz@myfairpoint.net>
Subject: Re: Topband: Covered /bare antennn wire
From: Eddy Swynar <deswynar@xplornet.ca>
Date: Thu, 15 Nov 2012 13:31:55 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
On 2012-11-15, at 3:42 PM, Bruce wrote:

> Dry blowing snow or high wind can cause quite some voltage build up on a 
> antenna, especially a long one. It is possible to draw quite an arc to 
> ground. 
> There have been reports of high voltage electrocutions from antenna static 
> build up in Short Wave Broadcast stations. A short stick was mandatory for 
> maintenance periods. 
> And yes, I did work at a shortwave station with 500 KW transmitter output.
> 
> So receiving antenna wire insulation could have some benefit if the voltage 
> on a bare wire is leaking to a tree limb or across an insulator. Beyond some 
> point all insulators can fail.
> 
> Indoor antennas do hear static, but I have never seen any evidence of voltage 
> build up. ( The building may provide adequate insulation.)  
> 
> 
> Out of curiosity, has anyone ever really done testing of voltage buildup on a 
> insulated antenna wire, VS a non-insulated wire ? 
> Indoor antennas VS outdoor antennas of equal size?
> 


Hi Bruce,

I am not so sure that the notion of insulated vs. uninsulated wire holds true 
in long wire spans...

Case in point: years ago when I first erected my 1500' long Beverage antenna 
here, I was specific in using insulated wire though its entire course because 
it runs through a grove of trees at one point. Well, one day, in the advance of 
an approaching storm front, I decided to ground the end of the Beverage in my 
shack. I could feel a "tingling" sensation as I man-handled the wire, 
negotiating my way to the common ground pipe that I have running the length of 
the back of my operating table...imagine my complete & utter shock as I neared 
the wire to this same pipe, and managed to induce 1/8" long blue arcs from the 
pipe to the wire!

Since that time---FWIW---I have always had a rugged 2.5 mh. RF choke clipped 
between the wire's end where it attaches to the matching transformer, and 
ground. In theory this acts as a static drain, I guess, but does not induce 
signals to ground. I've heard that a multi-megohm resistor will do the same 
thing at this point...

~73~ de Eddy VE3CUI - VE3XZ

_______________________________________________
Topband reflector - topband@contesting.com

<Prev in Thread] Current Thread [Next in Thread>