Topband
[Top] [All Lists]

Re: Topband: ALUMINUM

To: "Hardy Landskov" <n7rt@cox.net>, "Bob Kirkeby" <wb0dsf@gmail.com>, "Mike Greenway" <K4PI@bellsouth.net>
Subject: Re: Topband: ALUMINUM
From: "ZR" <zr@jeremy.mv.com>
Date: Sat, 9 Mar 2013 09:44:03 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
I use CATV hardline everywhere here and have had some left over bare coils on the ground for the 24 years Ive been here. Except for staining from leaves, etc it is still fine appearing. The ground is mostly leaves, twigs and pine needles. The bare cable CATV runs in this town have been up even longer and Ive been told by installers the operational life is expected to be 25 years or longer, unless it is subject to physical damage of course which is SOP from storms.

Carl
KM1H


----- Original Message ----- From: "Hardy Landskov" <n7rt@cox.net>
To: "Bob Kirkeby" <wb0dsf@gmail.com>; "Mike Greenway" <K4PI@bellsouth.net>
Cc: "TOPBAND" <TOPBAND@contesting.com>
Sent: Friday, March 08, 2013 2:24 PM
Subject: Re: Topband: ALUMINUM


Bob,
I had the same experience. I was using bare 75 ohm TV hardline as a matching
section on my 160 Delta loop and it was partially buried. But after 2 years,
the outer jacket was almost gone when I had to dig it up. My soil is just
regular sandy dirt.
So my advice to anyone that wants to bury aluminum cable or wire is make
sure it is insulated or jacketed.
73 Hardy N7RT
Phoenix


----- Original Message ----- From: "Bob Kirkeby" <wb0dsf@gmail.com>
To: "Mike Greenway" <K4PI@bellsouth.net>
Cc: "TOPBAND" <TOPBAND@contesting.com>
Sent: Thursday, March 07, 2013 10:24 AM
Subject: Re: Topband: ALUMINUM


I have used solid #10 aluminum as radials buried 6" in alkaline soil. It
became badly corroded in 2 years; nearly disintegrated in spots. Not saying
it wouldn't be fine in other soils.
73
Bob
WBØDSF

On Wed, Mar 6, 2013 at 6:31 PM, Mike Greenway <K4PI@bellsouth.net> wrote:

From some feedback on the aluminum coated steel, I am thinking about
trying some regular aluminum, 14 gauge.  Anyone got a downside to this?
 Price, weight, conductivity are good and little if any stretch.  I will
use aluminum screws and nuts on the end terminations with No Ox.  73 Mike
K4PI
_________________
Topband Reflector

_________________
Topband Reflector

_________________
Topband Reflector


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1430 / Virus Database: 2641/5659 - Release Date: 03/09/13


_________________
Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>