Towertalk
[Top] [All Lists]

Re: Fw: [TowerTalk] Tram

To: kb9cry@comcast.net
Subject: Re: Fw: [TowerTalk] Tram
From: rk <robrk@nidhog.net>
Reply-to: robrk@nidhog.net
Date: Fri, 19 Dec 2003 16:53:04 -0500
List-post: <mailto:towertalk@contesting.com>
"wrapped in around their hips" THIS WORSE THAN USING A TRUCK !! It's real hard to run real far, real fast, when things go bad...I quote a T-Shirt -- BOMB TECHNICIAN- If you see me running, try to keep up....

kb9cry@comcast.net wrote:

I would agree using a motorized vehicle, whether it's a tractor or car, to pull 
up an antenna or tower section either on a gin pole or other is dicey.  The 
problem is that you don't have feedback in the line that one can feel with your 
hands if something starts to bind.  Also there's a point where you want to inch 
the load up or down a smidge and you can't do that with a vehicle.  With my 
tower install, which was all gin poled up, two or three ground crew merely tied 
a big loop in the pull line and wrapped in around their hips and just backed up 
so they could watch the load being raised.  Once up, the installer would ask 
down a little and they just leaned forward a little and down it came an inch.  
It's real slick and under control.  Phil  KB9CRY
_______________________________________________

See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________


See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>