"near the house" How near? I reinforced the gable studs on one house
to be strong enough for a block and tackle. It lifted 30' of Rohn 25
plus 15' of mast extension with a TH7DX to a house bracket mount. The
hinged base was on a deck 1 floor up to yield 50' agl for the beam. A
strong tree or rope over the house ridge tied to a truck can also
provide a point to tie off a block.
A good lift point on a fixed tower is about 2/3 of the height. Pushing
it up or supporting it lower than 1/3 the height will likely bend or
break something, I've seen this done.
If you don't have a block and tackle rig, sometimes you can rent one at
a tool rental shop. Having had several sailboats, I'm partial to the
ball bearing sailboat blocks, since they are strong, weatherproof, and
have very low friction. Not cheap though!
Grant KZ1W
Gary "Joe" Mayfield wrote:
> I have an HDBX-48 that I hope to put up in a couple of months. The base is
> designed to allow for the tower to be tilted up. I am putting the tower
> near the house and do not have room for a falling derrick. Rohn is very
> vague about tilting the tower up/down.
>
>
>
> Anyone have some neat ideas or better yet pictures?
>
>
>
> 73,
>
> Joe kk0sd
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|