Hi Jim, it is not widely known but Belden 8214 does not have a
non-contaminating jacket. I just confirmed it on the 8214 data sheet on their
website
to make sure I remembered it correctly.
Too bad as it is a very nice coax otherwise.
73,
Gerald K5GW
In a message dated 6/11/2015 3:37:18 P.M. Central Daylight Time,
jim@audiosystemsgroup.com writes:
On Thu,6/11/2015 1:16 PM, Mark Spencer wrote:
> I have nagging doubts about using cables with a solid foil shield for a
rotor loop.
I would share your concern.
> I do like the idea of double shielded cables so RG213, RG 8 etc are off
the table for now.
I wouldn't worry about "double-shielding," but rather the quality of the
shield. Look through the Belden catalog for an RG8 or RG213 with a
robust copper braid shield and stranded center. Look at 8237, 8268,
8214. or 9251. All are 97% shield coverage. Check out vendors like
Markertek. 9251 has non-contaminating jacket. 8214 is #11 center; the
others are #13.
You don't need a lot of coax for the rotor loop, so cost is hardly a
factor -- I'd be more concerned about finding someone to sell you short
lengths. :)
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|