If you use loctite in aluminum, make sure you use primer or it won't set
properly.
73!
-Adam
WJ4X
On 7/28/2016 3:48 AM, Ian White wrote:
> Grant KZ1W wrote:
>
>
> If the threads in aluminium rotator castings aren't too badly damaged, a
> simple alternative is to use RED Loctite to fix short threaded studs
> permanently into the rotator base. (Even better, insert set-screws from
> inside the base casting to leave protruding studs, and again use Red
> Loctite.) During installation, the studs pass through the holes in the
> tower plate, locating the rotator safely in its correct position even
> before you add the nuts and washers.
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|