Towertalk
[Top] [All Lists]

[TowerTalk] Fwd: Fwd: Stacking question - another reality data point

To: towertalk@contesting.com
Subject: [TowerTalk] Fwd: Fwd: Stacking question - another reality data point
From: Hans Hammarquist via TowerTalk <towertalk@contesting.com>
Reply-to: Hans Hammarquist <hanslg@aol.com>
Date: Fri, 12 Aug 2016 11:46:17 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
 I realize that the idea probably has been discussed before. I don't have the 
possibility to test it (yet) but was wondering if it would enhance the 
communication better than elevating a single beam at different heights. 
Switching with relays etc is faster than mechanically running a bean up and 
down. Two (3, 4, 5) beams will also give better signal than one (I hope).

Hans - N2JFS


 

 

-----Original Message-----
From: StellarCAT <rxdesign@ssvecnet.com>
To: Hans Hammarquist <hanslg@aol.com>; towertalk <towertalk@contesting.com>
Sent: Thu, Aug 11, 2016 2:07 pm
Subject: Re: [TowerTalk] Fwd: Stacking question - another reality data point

Seymour, W6CCY does this ... or at least did at one time. He had 2 I believe 
6 element 20's spaced horizontally on two different towers and played with 
phasing (line length) to get them to work together. He said it was a real 
barnstormer.

Gary
K9RX

-----Original Message----- 
From: Hans Hammarquist
Sent: Thursday, August 11, 2016 11:48 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Fwd: Stacking question - another reality data point


I have had an idea for some time: When you feed all these stacked antennas 
in phase you will have optimum radiation to the horizon (or just above). My 
idea is to add switchable delay lines to the higher located antennas. (You 
could rather easily replace the damping networks in an attenuator with some 
coax do make this.) Thereby you will be able to get optimum angle for 
"higher up" propagation. You should select the steps to be small enough not 
to get "gaps".

Any taker? (K1TTT?)

Hans - N2JFS






-----Original Message-----
From: Tom_N2SR via TowerTalk <towertalk@contesting.com>
To: towertalk <towertalk@contesting.com>
Sent: Wed, Aug 10, 2016 9:49 am
Subject: Re: [TowerTalk] Stacking question - another reality data point

I used to operate at N3RS, who has 5/5/5 on 20, 5/5/5 on 15, and 5/5/5 on 
10.   I forget the specific stacking heights/distances, but IIRC, they are 
20:  37/77/117 feet, 15: 47/77/127 feet.  10: 25/50/87 feet.   I am using 2 
C31XR tribanders at 40 and 80 feet, with separate feedlines.   On 10, I have 
added a 5 element 10 at 25 feet, so while the distances are a compromise, I 
will have 3/3 @ 40/80 on 20, 4/4 @ 40/80 on 15, and 5/5/5 @ 25/40/80 feet. 
Which seems very similar to Tim's and well as Sig's stacking distances and 
heights.  I used HFTA not for the gain numbers, but as someone else pointed 
out, to eliminate or move the nulls for the arrival angles from Europe 
(mainly) and other directions.   As John also pointed out, I only have 1 
tower, and the C31XR's are just above the guy wires.  So that's what I have, 
and I have no plans to take the tower down to reconfigure the guy wires.  I 
know some guys have tribanders at 30/60/90 feet, but I chose not to do that. 
Tom, N2SR      From: "john@kk9a.com" <john@kk9a.com> To: 
towertalk@contesting.com  Sent: Wednesday, August 10, 2016 7:58 AM Subject: 
Re: [TowerTalk] Stacking question - another reality data point   These are 
logical stacking distances and will definitely work well formost stations. 
Most of us do not have dedicated towers for each band andwe have to adjust 
the spacing and heights to clear guy wires and otherantennas. Fortunately 
spacing distance is not overly critical. I usesimilar but slightly larger 
spacing and similar low antenna heights toK3LR except on 40m.John KK9ATo: 
<k1ttt@arrl.net>,    <towertalk@contesting.com>Subject:    Re: [TowerTalk] 
Stacking question - another reality data pointFrom:    "Tim Duffy" 
<k3lr@k3lr.com>Reply-to:    k3lr@k3lr.comDate:    Tue, 9 Aug 2016 
21:06:54 -0400I have 41 years experience in stacking 2, 3 and 4 Yagi's 
high.After many hours behind the HFTA and NEC model engines - then putting 
Yagi'sup in the air and using them for many years here at K3LR - these are 
thestacking distances that have worked very well at this Western PA 
QTH:Lowest Yagi height:40 meters - 118 feet20 meters - 50 feet15 meters - 40 
feet10 meters - 33 feetThen - stacking distances by band:40 meters - 72 
feet20 meters - 60 feet15 meters - 40 feet10 meters - 33 feetAll OWA Yagi's 
on all bands at K3LR have booms that are 48 feet long (itmakes a 
difference).73,Tim 
K3LR______________________________________________________________________________________________TowerTalk
 
mailing 
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
 
______________________________________________________________________________________________TowerTalk
 
mailing 
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>