I used my RigBlaster Pro to work the contest this weekend because I could
not get my W5XD Multi-Keyer to work with my Yaesu FT-1000MP Mark-V. I use
rig control on COM1 and have my RigBlaster Pro on COM4, with CW checked.
When I bring up WriteLog it keys the rig up with a carrier on CW until I
bring up the Port Setup screen and change the rig on COM4 from Ten-Tec
Omni-V to Yaesu FT-1KMP and click OK. After that the CW works fine. After
that I go into SETUP and SAVE CONFIGURATION to save the options and then go
to FILE and SAVE. When I close WriteLog and bring it back up it has
reverted back to Ten-Tec Omni-V on COM4. Any help with this or getting my
W5XD box going would be appreciated. Had the same problem with the W5XD
box, it would never save the Port Setup.
Alan, N5PA
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|