So far four ops have reported having the "No Rig" problem, i.e. when quickly
tuning up or down the band, the program loses the rig, and it stays lost.
These were using FT-1000, TS850, and IC756's.
I am used to seeing the No Rig after a quick dial movement, but it always
found the rig again right away. Not with v10.56C.
I reverted to using v10.55D, and the problem disappeared.
Apparantly, there needs to be a patch published.
Jim W4LC
----- Original Message -----
From: "Ted Huf W4ZE" <ted@w4ze.com>
To: <Writelog@contesting.com>
Sent: Sunday, December 04, 2005 16:23
Subject: Re: [WriteLog] Possible Problem with 10.56C No Problem
>
> I used 10.56C in the TARA RTTY contest and had no problem with the NO RIG.
> This was very prevalent before. The setup is IC-756 PRO3 and microHam
micro
> Keyer (ver 3.0.2.903 firmware 02.05). I have the rig baud set to 9600.
> Auto baud never did work good for me.
>
> I still have a problem with the FSK dropping out and sending only Mark.
Fix
> involves cycling the power to the micro Keyer by turning off/on the 756
> which is a pain because of the time for the rig to start.
>
> Ted Huf
> W4ZE
> Hickory, PA
> www.w4ze.com
> ted@w4ze.com
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|