>Eric,
>Hardwire the cw/ssb switch in the SSB position and use the switch as >your
>standby switch.
>Bob, W5AH
This is bad advice.
The SB220 should ALWAYS be started in the CW position to limit inrush
current. NEVER start the SB220 in the SSB position, as it puts too much
strain on components.
The best idea yet was to take the pot, remove it, and replace it with a pull
on / push off / potentiometer. This will allow you to still adjust the
sensitivity of the meter as well as give you an operate standby switch, AND
keep the amp looking stock.
Hope this helps.
Toll Free
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|